TE-123 Canister Sampler, US EPA method TO-14, US EPA method TO-15 |
|
| |
|
|
|
|
 |
| Support |
|
|
| |
|
|
|
| The Tisch 1-canister Sampler takes air from the inlet on the pump and injects it into the canisters at a constant flow rate for a preset time. The excess air is released through the bypass exhaust. The constant flow rate and elapsed time allow the operator to compute the volume of the integrated air samples. The samples are pumped through a Stainless Steel, Teflon diaphragm, 12 V.D.C. pump, which develop sufficient pressure to control the flow with a Porter regulator. The pump also samples the air at a flow rate (5 L/min) to keep any long sampling line flushed. A small, constant flow of sampled air is pumped into the sample canisters. The sampler will operate on 12 volts d. c. through a molex plug on back of sampler. The pointed end of the plug is positive (+) and the flat end is negative (-), and draws 5 amps. (ALWAYS USE A 5 AMP FUSE INLINE ON THIS 12V.D.C. INPUT) The a/c cord will take an input of 100-240 V.A.C. at 2 amps. |
- Meets requirements ofUS EPA Method TO-14 and US EPA Method TO-15
- Operation Instructions in menu format on LCD touch screen panel. Unique
ease of programming directly on touch screen
- Remote starting from site data logger
- Operation from 100-240v AC 50/60 HZ or 12 VDC battery or auxiliary
power from vehicle or solar panel
- Bench mount or 19” rack mount
- Stainless steel vacuum and pressure gauges for direct read of canister
- 3-way valve allows sampler purge and flow adjust directly before
canister port allowing the flow circuit to be removed from sample line 6
liter canister can be filled to 10 PSI in less than 40 minutes
- Additional channels available up to 7
- High flow pump to maintain maximum flushing of sample line to assure real
time integrated sample
- Pre filter made from PTFE for removal of particulate
- Very light weight and portable
|
approved for our instruments in Europe.
